Yay! The suit has reached milestone V1.2! The fur is finally the way it's supposed to look.

Up next is V1.5 where I have fan intakes where Crazy Joe put in ventilation at the ears. However, I'm finding out my head is a skin tight variety so there's almost no room. This project is on indefinite hiatus as a result.

I did find out the hard cast teeth finally split at one point. If you look closely, the cast is fully split with a visible crack. The 2 halves are only held by the glue underneath it, so there's a high likelihood the smaller piece can fall out after being used more. I seriously don't know what to do cause my warranty is void. 3D print new ones? Use that UV glue or whatever they call that? (the repair comes before the fan now, it will be V1.3)

Before I found out the crack existed, The suit would have been completed cosmetically other than the fan modification which wasn't cosmetic, but fate decided to be cruel once again and cracked my teeth.

I'm not doing well over the past few days, I just found out I have to be with my abusive Dad for 2 months while my mom had to fly out to care for my widowed Grandma in China. (Yeah, my Grandpa died right after VancouFur)